Observe changes in performance
Slower or uneven movement, unusual heat or abnormal noise are reasons to arrange a technical inspection. Record when the issue appears and whether it occurs under load or from start-up. These symptoms alone do not identify a specific failed component.
Record the condition safely
Stop the equipment according to its operating instructions when a hazard or significant leak is present. Follow the manufacturer’s isolation and depressurisation instructions before service. Never use your hand to find a pressurised leak or loosen pressurised components as a test.
Provide useful diagnostic information
Include the equipment type and model, the observed behaviour, any displayed messages and recent service work. External photos or a video taken from a safe position may help establish inspection needs; they do not replace a technical assessment.
Define the work before replacing parts
Problems can involve power, controls, oil, connections or moving components. A structured inspection supports an appropriate work scope and parts selection rather than replacing components without diagnosis.
Maintain a service record
Record the fault, work completed, parts replaced and post-service observations. This helps operating and maintenance teams monitor recurring problems and plan subsequent service. Contact Mqayes to discuss equipment inspection and maintenance requirements.
General safety reference: ENZED / Parker Hannifin. Follow the equipment manufacturer’s instructions and the site’s approved safety procedures.